Top-flite Nobler Manuale Utente

BUILDING and FLYING the

Another method to get landing flap operation with a 5 channel system is usea linkage in the plane similar to the elevator trim arrangement of reed con

PREPARATION FOR FLYING NOTICER/C Nobler is a full stunt plane but because of certain features it is apretty good trainer too It is always best to have

WING OVERS: Make the climb at half throttle and do the turn at l/4ththrottle Turns easily either wayCUBAN EIGHTS: In any Cuban eight maneuver use larg

The covering withthe built-in finishMONOKOTEMonoKote, acclaimed the greatest advance in coveringand finishing in model building history, will give you

S. E. 5. aNever before has an R/C scale model beendesigned with such attention to the most in-significant detail Wing Span 52" Eng 45to .60 Kit R

INTRODUCTIONIt has been suggested for several years that a control line stunter wouldmake a fine radio controlled model The fairly recent advent of mi

SUB-ASSEMBLIESTo speed building, by cutting down "waiting time," it is recommended thatcertain components be sub-assembled first.1. Glue F-2

FUSELAGE8. Pin F-ll in position on top view of fuselage. Pin both fuselage sides overplan upside-down, and glue to F-ll. Use Tri-Aids as shown in Fig

13. Slip all ribs W-l thru W-12 into spars egg-crate fashion. Do not glue jointsat this time! Pin all ribs over plan in correct alignment.14. Glue 1/4

WING19. Cut L. E. Sheet doublers from 1/16"x3" sheet and glue in place on wingfrom center to W-5. Glue 1/16" x 3" L. E. sheeting t

22. Glue 1/8" ply patch F-21 into hatch as shown in Fig. 14. Drill 3/16" holeand mount nylon plate. Glue 1/2" x 3/4" x 1-3/8"

35 Sand flaps and drill for flap horn (note offset — see plan). Install flapsand hinge temporarily to wing36 Mount three servos Make all pushrods as s

a system of in-flight uncoupling of the flap function was devised Maneuvers withthese planes, including of course the RC Nobler, could be made with an